How to home the slave sensor?

[ZASto]

Or better still one that uses UCCNC software like the AXBB-E or UC300 so you're not stuck with ancient mach3 or buggy mach4, plus you'll get decent technical support which you won't with an ESS.!

Anything against the ancients?
I'm dinosaur too (running Win XP, Mach3 on LPT)

[JAZZCNC]

Anything against the ancients?
I'm dinosaur too (running Win XP, Mach3 on LPT)

Nope, I too until about a week ago I run Mach3 on XP, all be it on Cslabs IP-S controller on my own machine. But I've been fitting UCCNC with AXBB-E or UC300 on machines I build for over a year now and it's blown me away how good it is. So when Mach3 crashed and wrecked a £150 job and £40 tool it was the last straw and I ripped it out.

UCCNC never does anything unexpected, never crashes for no reason, Feed hold works as it should and stops instantly, etc I could write a long list but won't other than to say if you ever consider changing then don't hesitate to go with UCCNC because I resisted for years but now realise I should have done it years ago rather than struggle being loyal to mach3.