OpenBuilds Style Build

[WoodKnot]

Giood morning Jazz

Please don't commit any more time to it please.

I need a bit of time now to consider my options.

Let me know what I owe you for your time please

Thanks

WoodKnot

[JAZZCNC]

Giood morning Jazz

Please don't commit any more time to it please.

I need a bit of time now to consider my options.

Let me know what I owe you for your time please

Thanks

WoodKnot

Hi,

Don't owe me anything and I would be more than happy to continue if you wanted, however, my honest opinion would be to start again with new profiles like 45x90 and re-use the rails and bearings rather than trying to make everything fit those profiles.

Just let me know if you want to proceed further.

Lastly, to make you aware the motors and electrics you have bought are also less than ideal so at some point, if you continue, expect to be upgrading these or if want to do it right from the start sell them and buy decent stuff.

[WoodKnot]

Hi,

Don't owe me anything and I would be more than happy to continue if you wanted, however, my honest opinion would be to start again with new profiles like 45x90 and re-use the rails and bearings rather than trying to make everything fit those profiles.

Just let me know if you want to proceed further.

Lastly, to make you aware the motors and electrics you have bought are also less than ideal so at some point, if you continue, expect to be upgrading these or if want to do it right from the start sell them and buy decent stuff.

Yes, thanks Jazz

Big decision time now - not sure at the moment which way to go................

As in, try to sell what does not work (most of it) and start from scratch, but be prepared to probably lose at least 30%

Or ditch the whole project and start again at some other point in time?

The plates that you have come up with are great, but agree that they 'don't look right' due to my mismatch of purchases.

Such is life

WoodKnot

[WoodKnot]

Ok, let's start again, bad idea?



So, by using 3 of the 2040 profiles to create the required space?

WoodKnot

[JAZZCNC]

Ok, let's start again, bad idea?
Attachment 30237
Attachment 30238
So, by using 3 of the 2040 profiles to create the required space?

WoodKnot

Can't see them.?

[WoodKnot]

Can't see them.?

They are there now, so one fits in the CBeam then one either side of the beam, or could put 2 at the bottom?

Just trying to make what I have work?

Thanks

WoodKnot

[JAZZCNC]

They are there now, so one fits in the CBeam then one either side of the beam, or could put 2 at the bottom?

Just trying to make what I have work?

Thanks

WoodKnot

Sorry not got back to you sooner Woodknot, I have just received the shipment of components for the next batch of Routers so we are full steam ahead building machines and time is scarce.

Don't think your plan will work very well or be any easier. I did have a little play around again and think I may have come up with a better way to do this and still use what you have.

Can you post a list of all the profiles you have and when I get time I'll try and finish off my idea for you to look at?