My UCCNC Probe Screen version 4 is available now

[Cube3]

Thank you for the explanation. Here is a quick video of the travel

https://youtube.com/shorts/GckmmolOtvo?feature=share

Hopefully you can see the settings. I tried quite a few settings with no change in travel directions

I am now going to install 1.2111 and try that.

Regards Simon

Sent from my COL-L29 using Tapatalk

[A_Camera]

Thank you for the explanation. Here is a quick video of the travel

https://youtube.com/shorts/GckmmolOtvo?feature=share

Hopefully you can see the settings. I tried quite a few settings with no change in travel directions

I am now going to install 1.2111 and try that.

Regards Simon

Sent from my COL-L29 using Tapatalk

No, I can't see your settings, but I can see that your machine, or probe, seems to be faulty, because you are probing very slow, but the machine just keeps going and bending your probe. Something is definitely seriously wrong, or configured the wrong way. Please read my manual once again, and if you want me to do do a quick test, please LIST the parameters as a text. I hope you don't expect me to capture that information, take notes and so on... AND help you also. I really don't have time, unless YOU make some efforts.

BTW, just like I said before, DON'T run the probing against any hard surface, unless you KNOW 100% that everything is fine. This way you are going to break something, and I am not responsible for that damage. Run your tests in the air, touching your finger, not a hard surface, until you know it's working as you would expect.