The illusive Boxford 260vmc

[irving2008]

well £24 delivered isnt bad...

blanking out 49 holes might not be as easy as you think, you might need to provide an alternate sensor. Also if you do blank the holes you'd prevent using it for closed loop speed control later...

[Ricardoco]

well £24 delivered isnt bad...

I liked the look of it, its fit for purpose and the price is not bad, although im not sure if i will end up buying another sensor, it will be interesting to see what that chip is on the back.

blanking out 49 holes might not be as easy as you think, you might need to provide an alternate sensor. Also if you do blank the holes you'd prevent using it for closed loop speed control later...

As always im thinking you are correct, maybe ill just mount another sensor on the spindle and be done with that, mind you i couldnt find anything suitable on fleabay

Rick

[Ricardoco]

This may sound stupid, but im just wiring up the drivers to the BOB and i was wondering if there were default ports used for axis, IE X=pin??? y=pin??? etc.. I do like to keep things default, as it makes things less complicated If I get problems.