Aluminium CNC log.

[JAZZCNC]

And I'm going to buy a reel of single core wire between 1mm^2 and just use it for everything. I would go multicore for the steppers and drivers but I don't need a reel of it costing nearly £100 from Farnell and don't know where else to get cable.

Here you go http://www.csecables.com/control-cab...trol-cable.asp buy just what you need.

Edit: Better link http://www.csecables.com/acatalog/Fl...rol-Cable.html

Mounting the rails behind the spindle plate in my Eyes isn't correct.

Well you need to go to Spec savers then. .:lol: . . Look closer and you'll figure out why.!! . . . It's quite obvious if you think about levers and lever length's.:question:

The rails mounted on the front plate make a big difference when it come to reducing chatter.!