Diy Brushless Spindle

[njhussey]

Far better than mine...wow has it been that long since I last looked at this....been too busy spending money on RC helis.

Bought a small boring bar and today in lunch bored the inside of the bearing holder out. Tomorrow will face off (parting tool not big enough) the part to the correct dims. Then just need enough Bellville washers to fill a 12mm gap...that offer of some washers still on Mark? ;)

Last bit is the cap then fit it all together...will take pics later!

[blackburn mark]

that offer of some washers still on Mark? ;)

itll cost you some pictures of where you are up to and how it works out with those 208 AC bearings

PM your address and the gap you have between your bearings

[njhussey]

Here you go Mark...pics from lunchtime's machining. The Ali has been in the bottom of a box of all my CNC bits from when I moved 2 months ago so is looking a bit worse for wear. If I can be bothered I'll skim the surfaces once it's done to tidy it up!