Steel frame cnc router design/build

**CraftyGeek** · 22-08-2013

Thanks Jazz - that kind of backs up my first thought.

Another quick Q on the welding front - how much cleaning do you do before welding new mild steel?
I've been searching & keep seeing hugely conflicting opinions - just a quick wire brush & then good to go?

**JAZZCNC** · 22-08-2013

Originally Posted by CraftyGeek

Another quick Q on the welding front - how much cleaning do you do before welding new mild steel?
I've been searching & keep seeing hugely conflicting opinions - just a quick wire brush & then good to go?

Well with stick welder then not critical has other forms like Mig-tig etc but still the better you clean the easier it will be to strike up and get good weld.
Just a quick whip over grind or flat wheel is enough just to remove any rust spots etc.

**CraftyGeek** · 23-08-2013

So it turns out that welding is quite tricky to master...who'd a thunk?...more practice & video watching required!

At least pillar drill tests with 10mm steel went smoothly - very happy drilling the stuff, but need some new taps.

**JAZZCNC** · 23-08-2013

Originally Posted by CraftyGeek

So it turns out that welding is quite tricky to master...who'd a thunk?...more practice & video watching required

Keep trying and it will click and don't get too stressed if your welds don't match those you see on the videos. Even pigeon shity looking will hold more than you realise. Weld 2 pieces together and then try to break the joint you'll be surprised how much effort it takes even with crap looking welds.!!

**CraftyGeek** · 23-08-2013

Originally Posted by JAZZCNC

Keep trying and it will click and don't get too stressed if your welds don't match those you see on the videos.

I'm not stressing over it at all - i'll get it...not convinced i've got the current setting nailed yet. Welding lines & dots on a flat surface are coming out nicely - 'T' joins are a bit of a mess but solid. I think i've only used 3 rods so far...another 10 & I might get the hang of it.
Overall though, I like it - very relaxing to do.

**JoeHarris** · 27-08-2013

Originally Posted by CraftyGeek

I'm not stressing over it at all - i'll get it...not convinced i've got the current setting nailed yet. Welding lines & dots on a flat surface are coming out nicely - 'T' joins are a bit of a mess but solid. I think i've only used 3 rods so far...another 10 & I might get the hang of it.
Overall though, I like it - very relaxing to do.

Relaxing until you blow your nose after burning a few rods and realise you are coating your insides with filth!