CNC Router V1.0 (For Cutting Multiple Materials)

[biketrialsdave]

I am now looking at the Y axis ballscrew mounts in a little more detail. In the screenshot below how is the bearing mount attached to the steel box section? (Does anyone have a link to this build thread btw?)



I assume that there's another piece of welded steel plate on the end of the box section? As below?



While I am on the subject of the "end plate", I assume some sort of adjustment will need to be built in to allow movement in the Z axis as if I use the epoxy method on the box section then it's going to add some height?

Dave

Is anyone able to answer any of the above? It would be great if there was a link for the red router listed?

Cheers,

Dave