Comments sought on new build: A CNC Router for RC Gliders and Planes

**Clive S** · 16-07-2015

Neil Looking good don't forget to put the rest of the bolts in the bearing mountings

**njhussey** · 16-07-2015

Originally Posted by Clive S

Neil Looking good don't forget to put the rest of the bolts in the bearing mountings

Cheers Clive. Yeah I know, I was adjusting them the other day and not got round to doing it....

**routercnc** · 16-07-2015

Hi Neil,

I found that the little bits and pieces take almost as long as the basic moving frame work! Keep plugging away and you will get there . . .

**njhussey** · 17-07-2015

Originally Posted by routercnc

Hi Neil,

I found that the little bits and pieces take almost as long as the basic moving frame work! Keep plugging away and you will get there . . .

Tell me about it Barry, too much fannying around doing the small things. The other trouble is that it's now holiday season and for the next 6 weeks there's one of us (only 3 in the office) out so I'm guessing all work will stop again on it as I'll be busy doing the day to day stuff and 3D drawing for quotes etc, hope not as it's getting nearer to the day that it makes the first chips!

**Gotty101** · 18-07-2015

Its looking great. One thing is there are atleast 4 rc modelers on here that I've seen now (including myself).

Im going to work on getting the fult signal from the hunyang vfd linked up but ive not seen anyone on here do this from my searches.

**njhussey** · 19-07-2015

Originally Posted by Gotty101

Its looking great. One thing is there are atleast 4 rc modelers on here that I've seen now (including myself).

Im going to work on getting the fult signal from the hunyang vfd linked up but ive not seen anyone on here do this from my searches.

Cheers! I've not looked at the VFD integration yet...that'll be the last thing I do I think.

First thing I cut will be a set of wing ribs!!!