Threaded View
-
14-11-2015 #8
Last Activity: 23-09-2018
Ah, right !
So given the main purpose of this machine is to make PCB's for my electronics hobby, perhaps I should factor in a new controller box to my development plan !
More good information, Thanks again .. .. .
S
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
SOFTWARE NEEDED TO RUN My CNC 3040T
By owen3371 in forum Machine Control SoftwareReplies: 5Last Post: 22-02-2020, 03:38 AM -
Cnc 3040t
By etNick studio in forum Milling Machines, Builds & ConversionsReplies: 7Last Post: 15-11-2014, 10:55 AM -
Chinese 3040T Arrives
By Gregor in forum Workshop & EquipmentReplies: 114Last Post: 11-07-2014, 05:55 PM -
DIY CNC router illuminated control panel
By wiatroda in forum Electronic Project BuildingReplies: 5Last Post: 04-06-2014, 11:19 AM -
servo control vs stepper control
By Peter. in forum Motor Drivers & ControllersReplies: 24Last Post: 17-09-2012, 08:36 AM
Bookmarks