Comments sought on new build: A CNC Router for RC Gliders and Planes

[njhussey]

Just watch your head.!! . . . . Got nasty habbit of twating you if not careful.!! . .

Got a lump forming as we speak on the back of my head already.....

[Wobblycogs]

Looking great Neil. At one point it looked lie you'd created a plastic fountain :-). Hope your head gets better soon.

[Clive S]

Got a lump forming as we speak on the back of my head already.....

How about a sensor on your head connected to the osh22t button Nice to see it in action though.

[njhussey]

How about a sensor on your head connected to the osh22t button Nice to see it in action though.

No because as soon as the oshiiiiiiiiiiiit button is pressed the gantry drops....... However........I do have my foam kneeling pad which I don't use anymore now it's vertical....I could put a couple of cable ties through the handles to loop under my ears to keep it strapped over my head!!!!

[Washout]

Nice vid Neil - lovely chip stream towards the end there.

BTW - would demi-jon bungs do for rubber stops or not man enough for the job - just a thought as the type for the airlock come pre-drilled iirc.

[njhussey]

Nice vid Neil - lovely chip stream towards the end there.

BTW - would demi-jon bungs do for rubber stops or not man enough for the job - just a thought as the type for the airlock come pre-drilled iirc.

Cheers Chris, the chips were fair flying out...I was finding them at least 3m away from the machine. Got to put sides on the machine and box it in to contain them all. Lots of little jobs still to do on it but I'm getting there... slowly!

They'd be good, not sure they're long enough. Will measure the length I need when I'm back off hols in a couple of weeks