New Build, Aluminium Frame Router/Mill

[Davek0974]

So far so good - no faults since wiring changes :)

Did have a probing error though - setting up for engraving plastic, 0.2mm 30deg 3mm tool in, tested the touch-plate as i always do, pressed the Z-Ref button, tool comes down and just keeps on going - pushed that little carbide bit through the pcb touch-plate, through 3mm of engraving plastic and a couple of mm into the machine bed :(

By the time i had hit the e-stop, the stepper was stalling, no idea why, i rebooted and it was ok for the rest of the day.

Scary stuff.