Thor, or should that be Zeus?

[mekanik]

Hi Chaz
This any good?
http://www.ebay.co.uk/itm/ANCHORSET-...8AAOSwq7JUGAUU
Mike

[Chaz]

Hi Chaz
This any good?
http://www.ebay.co.uk/itm/ANCHORSET-...8AAOSwq7JUGAUU
Mike

Thanks. Not sure.... anyone have experience of this? Google brings up loads of products however I dont want to pay school fees if someone knows what might work from previous experience. That said, £6.63 is worth a punt to try.

[Chaz]

I believe this should work. Sika are well regarded as far as I understand.

http://www.uksealants.co.uk/sika-anchorfix-1--p84.html

[Clive S]

Chaz I have used both of those in the past with great success. You will need to prepare all the hole first and blow any dust out. The nozzles on the tube are a duel flow type and in my experience cannot be used more than once so try and do the job at one sitting.

[Chaz]

Chaz I have used both of those in the past with great success. You will need to prepare all the hole first and blow any dust out. The nozzles on the tube are a duel flow type and in my experience cannot be used more than once so try and do the job at one sitting.

Thanks. If they are both good should I just buy the cheaper option?

[Clive S]

Thanks. If they are both good should I just buy the cheaper option?

Chaz I am afraid that the choice has to be yours alone. Are you using it to hold threading rod in a hole or bolt anchors?

[Chaz]

Chaz I am afraid that the choice has to be yours alone. Are you using it to hold threading rod in a hole or bolt anchors?

I have 2 requirements. The first is to hold M12 nuts in place that allow me to tighten the bolts holding the rails in place.

Secondary is similar where ill either sink nuts for holding and mount hardware the same way (motor mounts etc) or where Ill epoxy thread bar in place. My preference is to sink the nuts so I can use bolts from the top.

[Chaz]

Did you use the Red or Green Anchorset Clive?