CNCdrive UC300ETH Mach3 plugin is now available

[Lee Roberts]

This just got posted to the tube:



OK, so it looks as though you get the MB with the ETH version?

[JAZZCNC]

This just got posted to the tube: https://youtu.be/_1wqZFhTCVs

OK, so it looks as though you get the MB with the ETH version?

Still need BOB's or Isolation Lee they MB only provides headers which arent Optoisolated.

One thing that baffels me with this Company is they provide good hardware that is stable and with decent software/backup provide it on Motherboard with headers but then cripple it by not providing isolated I/O system that can handle 24V.

It wouldn't take much more effort or cost to add this and make it much more usable piece of hardware. I would use them in heart beat on machines I build if didn't require BOB and ran from 24V not 5V.

Shame.!!!

[magicniner]

I thought 24v inputs was not about being "professional" but was about being far less susceptible to EM noise, thus yielding a more robust system?

It's just occurred to me that I have a bag of postage stamp sized boards which do bi-directional conversion of signals between two different voltage levels ;-)

[JAZZCNC]

I thought 24v inputs was not about being "professional" but was about being far less susceptible to EM noise, thus yielding a more robust system?

100% correct and just how it should be done. 5V is ok running clocks.

[A_Camera]

I thought 24v inputs was not about being "professional" but was about being far less susceptible to EM noise, thus yielding a more robust system?

Again, that's taken care of by a £5 BOB.

[Ger21]

Still need BOB's or Isolation Lee they MB only provides headers which arent Optoisolated.

One thing that baffels me with this Company is they provide good hardware that is stable and with decent software/backup provide it on Motherboard with headers but then cripple it by not providing isolated I/O system that can handle 24V.

It wouldn't take much more effort or cost to add this and make it much more usable piece of hardware. I would use them in heart beat on machines I build if didn't require BOB and ran from 24V not 5V.

Shame.!!!

They designed and built a prototype two years ago, but had to shelf it at the time, as they were too busy working on their software and their ethernet boards. Hopefully at some point they'll get back to it.



If enough people ask them for it, maybe they'll get to it quicker.

[noyloj]

This just got posted to the tube:



OK, so it looks as though you get the MB with the ETH version?

Thank f&*£ for that! I just bought it!