Make sure both servos have exactly the same settings in the servo drives themselves. I do that by copy-paste-upload from one servo to the other in the servo tuning program. So i am 100% sure they work the same. Do so in mach 3 in motor tuning tab and make sure to hit "apply". Close. go out of mach 3, then do check again the result. Then make sure the direction of motors is set right before you rip your gantry.

Then test.Now all must work normal





About the dust, i see. You are right that dust extraction better not be choked down. I assume you will fit a kind of shoe there. Or you will extract only the fine dust not to float around in the air? I use sometimes my dust shoe only like that, without the brush attachment. Chips stay on table but no fine dust in the air.