Thor, or should that be Zeus?

**Chaz** · 12-06-2017

I need to order cable for limit switches (3 core for Proxy) and then 4 core for the Spindle / Earth.

Do I need either of these cables to be shielded? 3 Core cable is common, shielding adds a fair bit to the price. I dont mind paying if its absolutely needed however no point if its just a 'nice to have'.

Any suggestions for cable for the 4KW type Chinese spindles?

Thanks

**Clive S** · 12-06-2017

Originally Posted by Chaz

I need to order cable for limit switches (3 core for Proxy) and then 4 core for the Spindle / Earth.

Do I need either of these cables to be shielded? 3 Core cable is common, shielding adds a fair bit to the price. I dont mind paying if its absolutely needed however no point if its just a 'nice to have'.

Any suggestions for cable for the 4KW type Chinese spindles?

Thanks

Personalty I would use 4 core cy cable 1.5mm for the spindle

**Chaz** · 12-06-2017

Originally Posted by Clive S

Personalty I would use 4 core cy cable 1.5mm for the spindle

Thanks, what is CY cable?

**Desertboy** · 12-06-2017

Originally Posted by Chaz

Thanks, what is CY cable?

http://uk.rs-online.com/web/p/produc...FUQz0wod-YEKnA

any electrical wholesale should have it

**Clive S** · 12-06-2017

Originally Posted by Chaz

Thanks, what is CY cable?

https://www.cse-distributors.co.uk/c...creened-cable/

You can buy it by the Mtr.

**Chaz** · 12-06-2017

Thanks both.

And on the limit switches, screened or not?

**Chaz** · 12-06-2017

Suppose I can just buy 50 meters of this stuff and use for both the limits and spindle, done.

Its not a twisted pair but at least its screened.

**AndrewMawson** · 12-06-2017

As with Clive I always use shielded.

Pity you didn't mention it when you were over here at the weekend - I bought full rolls of SY cable for the limits and steppers on my CNC Plasma table and have a fair bit left

**Chaz** · 12-06-2017

Originally Posted by AndrewMawson

As with Clive I always use shielded.

Pity you didn't mention it when you were over here at the weekend - I bought full rolls of SY cable for the limits and steppers on my CNC Plasma table and have a fair bit left

No problem, thanks. You were already giving me free stuff, felt bad enough taking that, nevermind loads of other stuff too.

**Clive S** · 12-06-2017

Chas As Andrew has stated. Here is a link to see the difference http://www.control-cables.co.uk/. But if you are ordering you can get 3 core 0.5mm will be fine as there is hardly any current to worry about in limit and signal circuits. Everybody will have their own opinion of course but these have been tried and tested by many.