right its been a long while since i last updated this, I sent the control box back to planet CNC as it was faulty, I received it back pretty quickly a good while ago but have yet to plug it all in.......until tonight. Well the results were a bit disappointing,and now the motors will only move one way. I have sent another email to planet but even though im about £600 down on this control box I think I may need to buy another one which is wider used. Can anyone offer any advice as to if I should persevere with this box of just cut my losses and move on?

There are LED's on the front of the cnc control box but I cannot find anywhere what they mean as one of them is flashing and another is flashing red which obviously means something :-(