Losing steps/position, again

[ngwagwa]

You say "on the Network" are you trying to run this over a network ie: thru a switch or directly from PC to controller.?
Also are you using a patch cable or just an ordinary network cable because some network cables can be wired differently to others.!

PC connected to a hub then hub connected to controller, both standard cables nothing else connected and even tried 2 different PCs (I have a crossover ordered to try)

[JAZZCNC]

PC connected to a hub then hub connected to controller, both standard cables nothing else connected and even tried 2 different PCs (I have a crossover ordered to try)

Try it direct to controller first to elimnate the hub

[ngwagwa]

Try it direct to controller first to elimnate the hub

Direct connection and no joy, am trying to resolve with CNCdrive support



Yhey are telling me I need V1.8 or newer utility tool but I can't find it on their website.