eBay router

[cropwell]

. Our current bits allow cutting of 1050 sheet at 1150mm-1300mm - with a nice clean cut requiring minimal cleanup. We're changing to a slightly higher grade on next tool order to increase cutting speeds further.

I am intrigued to know what cutters, speeds, feeds and coolant you are using. I sometimes cut 1050 sheet (2 and 3mm thick) and it's the gooiest material I have found apart from some plastics.

[Chip Owner]

I am intrigued to know what cutters, speeds, feeds and coolant you are using. I sometimes cut 1050 sheet (2 and 3mm thick) and it's the gooiest material I have found apart from some plastics.

Zero coolant, it's not needed. Correct tool, feed and speed created the right chip dispersing heat, a mild blast to further help disperse the chips from a low pressure hydroponics pump is the only external addition.

I use bits supplied by LKHtools.co.uk