Boxford TCL 125

[John11668]

I do have a UC100 Jazz, so uccnc is not a problem. I was led to believe that to run Mach3 on a 64 bit computer I would need UC100 so am used to using that on a mill . Havent looked to see pin arrangement for lathe . I suspect we have a way to go before we connect the computer

[Doddy]

I do have a UC100 Jazz, so uccnc is not a problem. I was led to believe that to run Mach3 on a 64 bit computer I would need UC100 so am used to using that on a mill . Havent looked to see pin arrangement for lathe . I suspect we have a way to go before we connect the computer

Just to butt-in, use UCCNC for integration and all that, but it doesn't really support lathe operation at all well. That's the only reason I use LinuxCNC on my lathe.