Boxford TCL 125

[John11668]

I get the principle on the x limit Inee . I can probably rig one of those .
Am replacing the micro in my Fail safe switch . Seems to be switching but no positive click so I dont have a lot of confidence in it ,.
Where is the ring of interlocks connected to the boards . Wires are hard to trace with all the zip ties they have used.

[inee]

I get the principle on the x limit Inee . I can probably rig one of those .
Am replacing the micro in my Fail safe switch . Seems to be switching but no positive click so I dont have a lot of confidence in it ,.
Where is the ring of interlocks connected to the boards . Wires are hard to trace with all the zip ties they have used.

Cant remember where they connect on the board, what i did when i first got mine was to remove the cable ties and replace em loosely unit i got to the wires i was following, bloody tedious but i got there in the end, i loosely replaced em as it was easier to trace other wires.
just had a look at one of your pics to me it looks like the interlocks are wired to the top board in positions 7 and 8 of the connector which mostly went to the speed controller, havwe a look at one of your images I'm reposting, I've added a yellow circle is the wire in the yellow ring broken(orange wire).
Dead quick check is do a continuity test between those 2 orange wires pin 7 and 8.. if you get no joy try a check between one pin and every wire in the ceramic connector then try the other pin.

was going to log off then had a look at the pics
w