. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 22-06-2021 #13
    grantx's Avatar
    Lives in oxfordshire, United Kingdom.
    grantx
    Last Activity: 05-06-2022 Has been a member for 3-4 years. Has a total post count of 23.
    You are right. I dont know what I measured before....
    1 revolution gives 15mm travel on the Y axis (I havent measure the others)

    When I tell it to move 100mm (G0 y100) it moves 150mm.

    EDIT: Ok I remember how I measured it before. Using the auto-calibrate in Mach3 I get it to move 100 on the y-axis and it moves exactly that. It tells me the steps are 125, So that must be correct.

    I dont know what that G0 y100 command is doing ...
    Last edited by grantx; 22-06-2021 at 08:59 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Is this normal?
    By Pete147 in forum Control Hardware & Systems
    Replies: 5
    Last Post: 03-06-2021, 10:24 PM
  2. Is this normal?
    By A_Camera in forum Belt Drive, Pulleys & Timing
    Replies: 19
    Last Post: 28-04-2021, 08:12 PM
  3. Looking for an economical XY (well and Z) solution that is not for the normal use
    By SparkyLabs in forum Linear & Rotary Motion
    Replies: 27
    Last Post: 23-12-2020, 09:49 PM
  4. 1st time setting up.. whats normal..
    By Marlin in forum Motor Drivers & Controllers
    Replies: 26
    Last Post: 01-09-2014, 04:53 PM
  5. Looks like the normal first page has gone awry.... or is it my PC?
    By WandrinAndy in forum General Discussion
    Replies: 22
    Last Post: 03-10-2012, 08:05 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules