Quote Originally Posted by JAZZCNC View Post
You don't need a Water-cooled spindle but they are SOOOOOOOO much better than a standard router, with far less noise, stronger power, continuous duty cycle.

I sell them as a Kit only, this includes 2.2Kw ER20 Spindle, Huanyang VFD, 1 to 13mm Collet set, Spindle mount, water pump with the pipe. £265 + postage.
You will also need a shielded CY cable from VFD to Spindle which we can supply at £1mtr cut to length and will solder the VFD connector on free of charge.

You don't need any special wiring in the workshop and they will plug straight into a 13A supply if required. Occasionally, if you have a sensitive MCB in your Fuse box you may need to change the type from B to C MCB but this tends to happen mostly in very new properties and not very often.
Good evening Jazz

Sounds like a great deal to me!

Something that A Camera is unaware of, is of course the much needed and much appreciated help that you are providing me.

I would like to thank you for this help, otherwise I think I would have either packed in the project, or it would have taken me a year to build..

So based on YOUR design and I must state, some of the materials that you have been forced to work with, will my set up accept your spindle pack?

Thank you again

WoodKnot