step and dir pulse problem Mach3

[Kitwn]

im nearly there I think with wiring my Axbb-e , just got a few more questions.

Do I need to wire on off switch, if I do …how, or can I just plug in without it.
Wires coming from L1 AND L2 from back of VFD were do I locate these.
Is it ok to loop my 5v power supply from my 24v power supply or should I use separate supplies.
Cheers for all the advice and help..

I assume you mean loop the mains input to the supplies. That is no problem, just do it carefully. I would advise using the correct size crimped spade terminals rather than trying to twist several mains wires together.

You can have a mains on/off if you wish. I use a 4 way dis-board with individual switched outlets with separate feeds for the AXBB-E 5V/12V supply and the 36V motor supplies.

[mrmacca]

I assume you mean loop the mains input to the supplies. That is no problem, just do it carefully. I would advise using the correct size crimped spade terminals rather than trying to twist several mains wires together.

You can have a mains on/off if you wish. I use a 4 way dis-board with individual switched outlets with separate feeds for the AXBB-E 5V/12V supply and the 36V motor supplies.

Cheers for that. any idea where the red and brown wires from the VFD L1 AND L2 go onto the Axbb-e