Cuts are offline

[Andrew C]

if I was routering inside and outside the same vector should I rehome and re touch probe inbetween each process.

[JAZZCNC]

if I was routering inside and outside the same vector should I rehome and re touch probe inbetween each process.

If you don't move the material or part then you don't need to reset anything other than the Z height if you changed the tool. If you use the same tool then you don't need to do anything, just run your new code (provided you set the same X Y position in CAM)

If you move the material or part then you need to reset all axis.