Web Goblin cnc has begun

[Jonathan]

You dont need high flow or pressure just good head height. . . .

I compensated for that by putting the tank of water on a shelf at about the same height as the spindle.

As for a 1000l/m pump I seriously dont think you will get anything like that flow rate through the spindle.

I think Luke meant 1000 litres per hour...

Use Distilled water. . . Oh and the water is the same original water I started with 3+ years ago with no nasty's or funny smells, the fact It's distilled water and it's a sealed dark container that no direct sun light can get to helps (No windows in my shop).

I don't think distilled (or more likely de-ionised) water is required if, as you have done, you don't change the water. Once the water has deposited the calcium carbonate there is nothing more to deposit - it's essentially de-ionised. That does to an extent depend on the volume of water you are using (and where you live) as clearly if you have a 1000 litre tank there are a lot of ions it there to start with, and vice versa.

A few months ago my workshop was broken into but thank fully we caught one of them.! . . wont go into details but lets just say we got the stuff back and real justice was served. .

I take it you signed the relevant petition then recently.

[JAZZCNC]

I take it you signed the relevant petition then recently.

Nope.!!. . . but I dont know what petition you mean anyway. Thou would a petition really stop the scum bags .?? Me thinks not.!