Dyna mechtronics DM3000 lathe , mach conversion

[dazza]

Had a poke around the spindle motor area took off the wiring cover to reveal the connection block.
the block is printed with he following wire colours to each letter
T1 RED
T2 BLACK
K1 RED
K2 BLACK
A1 WHITE
A1 BLACK
B1 RED
B2 BLACK
.edited i completely missed the pin out info on the back of the lid so will stick below as I couldn't find it on line edited..what are the K1and K2 wires with the T/0 below it ?
SEM MT30 U4-48
.
Attachment 13223
Attachment 13216

second question I have is..
with me using the heds encoder and plugging that into the dc servo drive as the manual instructs,
is the optical sensor that sits on top of the spindle and the tach no longer required??

I don't understand why I would need 3 forms of feedback yet they were all installed as standard when the lathe was in its original state.

[dazza]

It turns out I don't need to be concerned with anything other than the encoder so I don't need the rest
im on the wiring next,it wont be pretty.


ive no experience with electronics but I should be ok with wiring the drives getting the motors moving etc
one thing im struggling with and cant find info on is the tool turret card and the 24v solenoid that operates the turret lock and how/where I would go about wiring these into the pmdx 126 board.
EDITED Found the info for the board

[EddyCurrent]

..what are the K1and K2 wires with the T/0 below it ?

thermal overload, over temperature probably

[dazza]

right apparently I can use the k1 relay on the pmdx board to work the turret solenoid .
does the wiring from my turret board to the pmdx look ok in the image below?if so can/should I daisy chain the grounds on the pmdx?
Ive also received an email telling me as the lathe has a turret I will need either a smooth stepper or a second parallel port.. so im thinking this if anyone has any thoughts on it.http://www.cncdrive.com/UC300.html

[JAZZCNC]

Not sure if the PMDX is common gnd (Edit: Looks like it is) or if the 5V Gnd is isolated from the inputs.? If common gnd it will use the 5V supply Gnd as it's potential ref so won't need jumpers. If not then you will need you to connect the Input Gnd's to 5v supply Gnd's. In either case won't hurt to daisy chain if unsure.
Same if you use external 5V or 12V you will need to reference Inputs to that supply's Gnd.

[dazza]

edited now braking for spares.moved on.

[Jonathan]

Getting there :)

From the video it sounds like the solenoid on the ATC, which holds the tool rack rigidly, is not being activated. Once it's wired up (using a spare relay on the PDMX or an external one, with the 24V psu) you can configure it to one of the outputs then add a line to the vbscript which runs the ATC. For example if you set the solenoid on to output #2 and put the correct pin for the relay, then you just add the line 'DeActivateSignal(OUTPUT2)' to the start of the script to switch the solenoid off so the rack can rotate, then put 'ActivateSignal(OUTPUT2)' at the end of the script to switch the solenoid back on.

[mikeyz3385]

Hi everyone, diesel were you able to successfully complete building your dm3000? I purchased one a couple months ago and am in the process of converting mine to mach 3 but I wanted to ask you a couple questions if you don't mind.