Comments sought on new build: A CNC Router for RC Gliders and Planes

[Clive S]

I think I'll make some myself when the machine is up and running, although it'll be tight for the Z axis motor as it's quite near the plate.....and I've got a Nema 34 on the X axis......

If you want the dxf etc give me a shout.

[njhussey]

If you want the dxf etc give me a shout.

Cheers Clive, would appreciate the DXF and any other files you have....save me from re-inventing the wheel!!

[njhussey]

OK so today I'm back on the limit switches. Below is the diagram I currently have, is there a way using the relay that I can have seperate inputs from each limit switch or is it not needed?



I'm going to have travelling switches on each axis (apart from the Z where I can probably get away with fixing it and have the trigger points on each end of the Z axis) and wire them back in shielded 3 core cable...

The home switches I'm going to wire individually into the CSMIO IP-M.....