Comments sought on new build: A CNC Router for RC Gliders and Planes

[Noplace]

Up ended the router, b*@@#r me it's quite heavy!



Notched the corners of the 20mm plate and chamfered where the weld beads are. Put the plate on the base and used an 8.5mm transfer punch to mark the bolt holes.



Drilled and hand tapped the plate...



Put it on the frame and tightened the bolts up...



And then put foot pads on and put it down on the floor for the time being....

looks awesome, mind pointing me to where you got those leveling pads? thanks!

[njhussey]

looks awesome, mind pointing me to where you got those leveling pads? thanks!

I got them from RDG Tools http://www.rdgtools.co.uk/acatalog/1...dia-14743.html when I got a load of other bits (8" Vertex indexing head etc...) I'm sure they're not the cheapest by far but I was ordering loads of other goodies.....