. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 07-12-2015 #12
    JAZZCNC's Avatar
    Lives in wakefield, United Kingdom.
    JAZZCNC
    Last Activity: 19-01-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 8,446. Received thanks 1,445 times, giving thanks to others 109 times.
    Don't bother changing to 64bit OS because Mach3 PP driver won't work with it. 32bit only.

    Do your self a favor and don't waste any money buying PP card just save then money and put towards motion control card.

    When you do get the card working find the i/o address in resource manager and then in mach make sure you enter 0X(Zero) then address.
    Last edited by JAZZCNC; 07-12-2015 at 05:45 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 3 users browsing this thread. (0 members and 3 guests)

Similar Threads

  1. usb - parallel
    By universally in forum Gantry/Router Machines & Building
    Replies: 4
    Last Post: 12-03-2015, 04:03 PM
  2. Mach3 ports and pin setup to match my control box
    By Sparky in forum Artsoft Mach (3 & 4)
    Replies: 17
    Last Post: 13-11-2014, 04:00 PM
  3. New Motherboards and LTP1 ports. (You might have one)
    By Mattbatt in forum General Electronics
    Replies: 0
    Last Post: 05-04-2013, 10:12 AM
  4. ports and pins for system4
    By Dan Brown in forum Motor Drivers & Controllers
    Replies: 2
    Last Post: 18-01-2010, 06:37 PM
  5. Ports and pins help ? mach 3
    By xchipx in forum Artsoft Mach (3 & 4)
    Replies: 0
    Last Post: 19-04-2009, 12:45 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules