Cnc plasma build need help plz

[Lewywri89]

I had it running the other day but so slow it was barley noticeable
But since I plugged in the software cable in when it was on one drive wouldn't work
Then I didn't notice the cable pins were burnt until I plugged into the next drive and couldn't unplug it
The port on the first drive however looks fine

Sent from my D6503 using Tapatalk

[Clive S]

I had it running the other day but so slow it was barley noticeable
But since I plugged in the software cable in when it was on one drive wouldn't work
Then I didn't notice the cable pins were burnt until I plugged into the next drive and couldn't unplug it
The port on the first drive however looks fine

Sent from my D6503 using Tapatalk

Sorry but you are not making a lot of sense. It is difficult to know what is actually wrong. You need to do methodically one step at a time and give clear answers.

So do any axis work if so which one and does it move the correct commanded distance?

Have you checked if there is a PD between the drive case and the PC because putting the protune plug in should not have caused a burn up.?

Try and get just one axis working first.