How to get this finish?

[andy_con]

not sure dulux would cut it, especially watered down. ive got some mdf primer from wickes and its ok but not great

If it was me I would spray the finish, dulux undercoat with dulux liquid gloss for the top coat. Thin them both down enough that they pass well through your spray system but also coat the job well, light sand in between coats and the job should turn out very nice.

With any paint job, the finish is a result of the prep, so on this, only you can decide what level of prep your willing to go to.

Edit/tip: Warm the paint up in the tin first as it makes it much easier to apply and with good spray gear you may not need any thinning.

.Me

[alboy]

The type of finish you are after is attainable but only with considerable time and money. Normal household paints or automotive rattle cans just do not cut it. Only one way I have found to get a decent finish on MDF.

Sand well with fine grit sanding wheel.
Apply MDF sealer,
Sand lightly again.
Use a 2 pack Hi-build primer.
Light sand with 600 grit paper.
2 or 3 coats of 2 pack finish colour,
2 or more coats of clear coat.

If you want to go this route you will need a good quality air fed spray gun, a spray booth and good PPE because the 2 pack is nasty stuff if you inhale it.

Commercial furniture spray paints are available that can do the job much easier but are expensive and you have to buy at least 100 litres at a time.

Good luck

[andy_con]

Im not after perfect juaf after a good finish

Thanks for all thd advice

[Lee Roberts]

not sure dulux would cut it, especially watered down. ive got some mdf primer from wickes and its ok but not great

I am, o it's oil based by the way, good luck.

.Me