CNCdrive UC300ETH Mach3 plugin is now available

[JAZZCNC]

Jazz, no it's the full figure 126999ft which is about £350, I did post earlier which for a breakout board is stupid.

WTF!!! . . . They have been sipping on too much Palinka if they expect to get that for it.! . . . That Kills that then.!

[m_c]

WTF!!! . . . They have been sipping on too much Palinka if they expect to get that for it.! . . . That Kills that then.!

That made me laugh. Is there any country's favourite drink you don't know?

[JAZZCNC]

That made me laugh. Is there any country's favourite drink you don't know?

My mates Dad is Hungarian and made this drink in his shed. When we were kids we nicked some from shed got pissed as newts.!! . We got leatherd for it but was worth it.

[noyloj]

WTF!!! . . . They have been sipping on too much Palinka if they expect to get that for it.! . . . That Kills that then.!

Well I hope that the kit I bought comes with a motherboard! There is no mention of any additional components needed, as far as I can see, on the CNCdrive website...

IDC26-DSUB25 female ribbon cable assembly L=250mm (to use with the UC300-5LPT) (x1): 3.5 EUR

[BRK0003] HDBB2 breakout board (x1): 50 EUR

UCCNC software + UC300ETH-5LPT ethernet motion controller bundle package (x1): 175 EUR

Total: 228.5 EUR

Hhahaha! You're gonna slay me if I goofed up!

[Ger21]

The 5LPT is the motherboard, so yes, it should come with one.

[noyloj]

Thanks Gerry! Phew! I would have been toast man! Hahha!

Bearing in mind that I bought this with their own breakout board (not the cheapest at 50euro) it's really not too bad... comparable to the SS purchase price here in the UK...

I got their BOB because I just don't want any problems with compatibility... I have enough hurdles to consider electronic/electrics wise what with connecting up the drivers/motors correctly without avoidable communication problems.

[Clive S]

without avoidable communication problems.

Of course that may be a problem

[noyloj]

of course that may be a problem

lol!