Tank3d printer build

[Robin Hewitt]

I am halfway through a print, I will do a couple of links when it finishes

[Boyan Silyavski]

I am halfway through a print, I will do a couple of links when it finishes

Check that one too. I just finished adjusting the link pins, as they were too long i think and as i said assembly had to be done under hot water. And i broke some mean while . Due to the newly introduced slot which was supposed to help mounting it together.


I am just going to print that new variant and check if i resolved the issue.Cable Chain X.stl otherwise it moves very nice and has bend radius of mere 55mm, chain is 25mm wide x 20 high outside