Warco WM16 CNC Conversion.

[njhussey]

Stick the screw in the lathe chuck (with something protecting the screw) and use a drill chuck in your tailstock with the chuck jaws wound right in to keep it square, wind the chick.in as you spin the die (not the chuck)....that's how I do it....😁

Sent from my HUAWEI VNS-L31 using Tapatalk

[noyloj]

Stick the screw in the lathe chuck (with something protecting the screw) and use a drill chuck in your tailstock with the chuck jaws wound right in to keep it square, wind the chick.in as you spin the die (not the chuck)....that's how I do it....��

Sent from my HUAWEI VNS-L31 using Tapatalk

Hi Neil

This is something like what I wanted to do but the 2MT taper on the rotary table is too small to take the 16mm ballscrew...

What do you mean with about using the drill chuck to keep it square btw?

Ah... I gotcha!

Thanks Jo