DDSCV1.1 3 and 4 axis offline motion controller

[foto-boss]

And how are you going to use DDSCV1.1 with them?

[magicniner]

And how are you going to use DDSCV1.1 with them?

I am addressing your insistence that modern CNC machines are built enough out of square to require software compensation to cut a right angle, I used manual machines as an example that it is quite obviously possible to produce machines with ways which operate with precision and without need of compensation and has been for the best part of a century.

But you knew that :D

[foto-boss]

I have a strong suspicion that these machines were made not by you, but by the factory.