New start

[A_Camera]

Hi Nr1madman,

Where in Sweden are you located? I have a UC300USB resting on the top of my PC, gathering dust. I only use it occasionally to test things, or to run Mach3 without the CNC, and of course, it is also a spare unit, since the base (motherboard) is the same as for the UC300ETH, so I want to keep it, but you can borrow that and see if it helps.

[Nr1madman]

Hi Nr1madman,

Where in Sweden are you located? I have a UC300USB resting on the top of my PC, gathering dust. I only use it occasionally to test things, or to run Mach3 without the CNC, and of course, it is also a spare unit, since the base (motherboard) is the same as for the UC300ETH, so I want to keep it, but you can borrow that and see if it helps.

Sounds awesome :D

I'm located in Trosa just south of Stockholm.
You?

Before I'm going on a borrowing roadtrip I'm going to try with a new computer and if that don't work I will try running mach3 (a friend has a license) .
I'm not hoping that mach3 will solve this as I rather like uccnc :)
If all fails I will gladly take you up on your offer!

Skickat från min SM-G955F via Tapatalk

[A_Camera]

Sounds awesome :D

I'm located in Trosa just south of Stockholm.
You?

Before I'm going on a borrowing roadtrip I'm going to try with a new computer and if that don't work I will try running mach3 (a friend has a license) .
I'm not hoping that mach3 will solve this as I rather like uccnc :)
If all fails I will gladly take you up on your offer!

Skickat från min SM-G955F via Tapatalk

I am located just outside Lund, so it is a long road trip... cheaper if Postnord does the trip. :) Anyway, only the motherboard can be used for test since the UCCNC license is based on the main CPU board. This means that the USB connector and the handling of communication and processing can't be swapped out.