Let the fun begin !!! ???

**PAULRO** · 05-02-2015

more pics .the motor config. is repeated on the far side .

**JAZZCNC** · 06-02-2015

Originally Posted by PAULRO

more pics .the motor config. is repeated on the far side .

Why do you have what looks like a 3:1 ratio on the screws.? Even with a 10mm pitch screw 2:1 is bad idea if your planning on using as wood router.
2:1 ratio will slow you down to around 5 or 6mtr/min max rapids and for woods you'll want to be cutting at that. 3:1 would be even worse.!!
Stay with a 1:1 ratio is my advise if your cutting woods.

Regards the motors then it's preference thing mostly 2 x 3 or 4Nm 23's will easily handle 65Kg. I prefer single motor with belt for accurecy and piece of mind reasons but I'm equaly happy to use slaved motors provided the correct drives and precautions are used. Slaved motors work ok but I would only use them provided you have Digital drives that can detect stalled motors or have fault output so you can E-stop the system.
Digital drives have made slaved motors much safer in my opion with less stalling as they handle current so much better and can easily detect for stalls. They also dont loose steps as much as the old drives did.

**PAULRO** · 06-02-2015

it's a 2:1 ratio. 18 tooth on the motor and 36 on the screw. i read a post in one of the blogs here that 2;1 ratio would be good for detail work but i can change to 1:1 if i could still achieve the required detail. thanks for the advice on the digital drives though.

**JAZZCNC** · 06-02-2015

Originally Posted by PAULRO

it's a 2:1 ratio. 18 tooth on the motor and 36 on the screw. i read a post in one of the blogs here that 2;1 ratio would be good for detail work but i can change to 1:1 if i could still achieve the required detail. thanks for the advice on the digital drives though.

What kind of detailed work.? 1:1 ratio on 10mm pitch will get you this kind of detail.

**PAULRO** · 06-02-2015

that will do it for me so . i'll go with the 1:1 . i could replace the 18 tooth pulley for a 36 tooth pulley to create a 1:1 ratio or replace the 36 tooth pulley for 18 tooth pulley . i suppose it wouldn't matter either way , or would it? i'll replace the 36 tooth pulleys and be done with it.
excellent work on the calender. if i can reproduce that detail i'll be more than happy. i might get some more details on the M/Cing of that when the time comes , if you don't mind.

**PAULRO** · 06-02-2015

By the way Jazz , i just had a look at the u tube video of leadshine closed loop stepper(https://www.youtube.com/watch?v=ZMZdCcLQc4M) you posted and i have a couple of queries.( great video, by the way) would it be worth my while to attach encoders to my nema 23s?. i had planned on using AM882 drivers but i don't think they take feedback signals. i know they have stall detect ( you mentioned that previously).i would like to get as much info. as possible before i decide to press the BUY button. the closed loop system is a more attractive option in terms of constant feedback but that's as much as i know at this point.

**PAULRO** · 06-02-2015

i had some play in the fixed bearing blocks (0.3 mm) . stripped them down and set them up again and still had end play. had to make some shims to eliminate it .