big budget cnc

**pet30** · 13-07-2017

witch driver is the best for those stepper motor's ?

can i use arduino uno with the drivers?

its because i want to use estlcam and it works with arduino uno or xPRO V3 Controller Stepper Driver so can i use these with the drivers?

**Clive S** · 13-07-2017

Originally Posted by pet30

witch driver is the best for those stepper motor's ?

can i use arduino uno with the drivers?

its because i want to use estlcam and it works with arduino uno or xPRO V3 Controller Stepper Driver so can i use these with the drivers?

AM882 are a good choice for the drivers. With 68V power supply.
Why would you want to use arduino uno to run a router?

Any software will work with the drivers.

**pet30** · 29-08-2017

Got the steel since friday i was a lot and very heavy.
this weekeind i started to weld everything together with a small inverter and it works very well.
Just a question do i need to bolt the machine to the floor ? do i need to put rubber between the bottom of the legs and the floor to have the less vibrations?

Click image for larger version.

Name: 20170826_090221.jpg
Views: 341
Size: 984.0 KB
ID: 22692

Click image for larger version.

Name: 20170824_174832.jpg
Views: 311
Size: 1.01 MB
ID: 22693

Click image for larger version.

Name: 20170826_081922.jpg
Views: 300
Size: 618.2 KB
ID: 22694

**Clive S** · 29-08-2017

Just a question do i need to bolt the machine to the floor ? do i need to put rubber between the bottom of the legs and the floor to have the less vibrations?

No. No need to bolt the machine to the floor I have mine on castors but when it is in place I lift it off the floor on wooden blocks otherwise it would walk about.

**Neale** · 29-08-2017

Like Clive, my machine sits on wooden pads under each of the adjustable feet, which can be lifted to make use of the castors. The plan was to make the machine mobile so I can pull it away from the wall if I needed to work on long lengths of material. Wood or hard rubber (like the commercial adjustable feet) are fine.

**pet30** · 04-09-2017

just a question

the supported round rails ( not hiwin etc)

Click image for larger version.

Name: Ondersteunde as lager.jpg
Views: 625
Size: 123.5 KB
ID: 22709

those carts how many kg can they carry , because my gantry is becoming very heavy.

My rails are the SBR 20

**pet30** · 13-10-2017

i got a lot of work done this weekend

the machine has finaly got the rails mounted and they run very smooth
the gantry rails mounted
everything is welded and made grinded for paint
next weekend i will paint the machine

then i need to move the machine on its right place level

mount the r&p, the motor's, drivers etc so a lot of work but i am very happy with the result so far

a couple of my friends where shocked to see this