Web Goblin cnc has begun

[JAZZCNC]

Some photos are attched of the cut edge. Quality looks good for an old cutter.

Hi Ian,

Congrats on your first Hot Chip's. . . . . . . (Now the BUT.:lol:)
I think your single spindle mount is causing chatter/resonance looking at the edges I can see chatter lines.!
I know you say the cutter was old but that does look more like flex chatter..? Also when cutting it sounded ringy more like a resonate ring not a blunt cutter.

Too little DOC, too slow spend n feed or more importantly wrong chip load can be just as bad for cutter than too much, esp in sticky Ali. Don't be shy give the cutter some work to do as your going far too conservative. . . .Heat is the enemy so send it away with the chip.!!