Threaded View
-
12-01-2016 #26
Last Activity: 26-03-2024
I just ran it again at a slower feedrate and it completed ok. Not happy though. Would love to understand what happened.
Also I noticed that when I was surfacing my table the other day (using Jog), every now and again the jog would stop while I still had my hand on the key.
However no reason was given as to why by Mach3. No limit switches tripped etc. I had to reset the machine before i could continue. This must of happened 10 times during my table surfacing.
Do you think this could be down to Noise ?
Anyone got any suggestions ?
Thanks MartinLast edited by mturneruk; 12-01-2016 at 09:50 PM.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Chinese 300W DC spindle - is the spindle shaft grounded?
By HankMcSpank in forum Spindles & Drive MotorsReplies: 44Last Post: 26-11-2016, 07:25 PM -
1.5Kw Chinese Spindle help
By Hasanain in forum Generic Chinese SpindlesReplies: 3Last Post: 26-05-2016, 10:38 AM -
WANTED: 2.2 KW Chinese Spindle
By Chaz in forum Items WantedReplies: 2Last Post: 17-06-2013, 10:03 AM -
Electronics upgrade for an existing machine.
By Shinobiwan in forum Electronic Project BuildingReplies: 9Last Post: 18-03-2012, 04:01 PM -
WANTED: Spindle holder for 1.5kw Chinese spindle.
By jcb121 in forum Items WantedReplies: 19Last Post: 14-10-2011, 02:07 PM
Bookmarks