Aluminium Extrusion Router Build

[JAZZCNC]

Hi Jazz, that Lichuan drive does look very nice, if I go down the nema 34 route instead of twin motors on the X axis. For the nema 24 motors I was looking at the Leadshine CS-D508 drive which appears to be very similar to the Lichuan LCD375H drive or maybe the Leadshine ES-D808 which I think is similar to the Lichaun LCDA808H that you used.

I've also used the LCD375H and they are ok as well but let down by only being 50V which means running around 44V which ideally more would be better.

Even a CSMIO IP-S is roughly £150 cheaper if you buy it directly from CS Labs, and there is no customs charge as it's from the EU.

Carefull here because in Poland you'll pay I think it's 23% Vat on top of web price shown then think it's about £36 carriage so difference might not be that big. Gary doesn't charge shippping over £250.

I've got another small question, how much distance does the motor shaft have to go into the HTD pulley. If I used 15mm belts and pulleys which are approximately 25 to 30mm wide, if I loose 3mm to the mount would there still be enough shaft length to securely hold the pulley?

If what your saying is you'll lose 3mm. Ie: lets say pulley boss is 30mm wide and your 27mm into it then yes that will be perfectly fine.
Can get away with 3/4 into the the pulley width any less and your pushing it.